#PROGRAM A CRAFTSMAN GARAGE DOOR KEYPAD HOW TO#

Then, adjust the multimeter to the “continuity” setting and touch the leads to the terminals on the reed switch. You’ll need a multimeter to check if there is power going to the reed switch.įirst, disconnect the opener from the power source. You will find the reed switch on the opener’s motor unit. You can also check if there is power going to the reed switch. If they’re not, the opener won’t be able to pick up the signal from the remote. The sensors should be pointing directly at each other.

If that doesn’t work, try realigning them. If the sensors are dirty, they might not be able to pick up the signal from the remote. The sensors tend to be on either side of the garage door. Check the opener’s sensors if you’ve tried replacing the batteries and the opener still isn’t responding. Beyond that range, the opener will not receive the signal from the remote.Īnother possible issue is that the batteries in the remote might be weak and need replacing. The Craftsman garage door opener has a range of up to 100 feet. If your opener doesn’t respond to the new remote control, you should check if you’re out of range. How Can You Troubleshoot Craftsman Garage Door Openers? If it doesn’t open, repeat steps four and five. If the door opens, it means you’ve successfully programmed the garage door opener. You can stand in front of your garage and press the “Open” button on your remote. Step 6: Test The New Remote Controlīefore you put the ladder away and call it a day, you must test the new remote control. The indicator on the opener will flash to show that it has received and stored the signal. The opener will receive this signal and store it in its memory. Pressing the remote control’s “Open” button and the “SRT” button simultaneously will signal the opener. Step 6: Press The Remote Control’s “Open” Button And “SRT” Button Simultaneouslyįind the “SRT” button on the back of the mounted garage door opener and press it. If it starts blinking, the opener is in learning mode and ready to receive instructions from the remote. Now that you’ve located the “LEARN” button, press and hold it for a few seconds before releasing it. Step 4: Press And Hold The “Learn” Button For A Few Seconds

The garage door opener is the box attached to the garage ceiling, so use a sturdy ladder. Utilizing a ladder, climb up close to your garage door opener. Step 2: Get A Ladder And Climb Up To The Opener Ensure the remote control shares a manufacturer with the opener for easy compatibility. You must purchase a new garage door opener compatible with your Craftsman garage door openers.Ĭompatibility is vital as it facilitates communication between the opener and the remote.

#PROGRAM A CRAFTSMAN GARAGE DOOR KEYPAD HOW TO#

Here is a step-by-step guide on how to program craftsman garage door openers: Step 1: Purchase A New Garage Door Remote You will have to program the garage door opener all over again. Most of the garage door openers stop functioning with the old remote, necessitating the purchase of a new remote.

Older units will have a different procedure, however. How To Program Craftsman Garage Door OpenersĬraftsman garage door openers are currently manufactured by Chamberlain, so the steps to program them are similar.

Program a craftsman garage door keypad